Fronius Robacta Reamer X-Line J, Operating Instructions Manual

Page: 36 / 76

Adjusting the Position of the Cleaning Motor
Adjusting the
position of the
cleaning motor
(4) (6) (5)
(1)
(2)
(3)
1
Remove protective cover (1)
2
Remove the gas nozzle from the torch
body
3
Loosen the screw (2) on the lifting
device
4
Make sure that the lifting device (3) is
in the bottom lift position
5
Position the welding torch in the clean-
ing position (approx. 1 - 2 mm/0.039 -
0.079 in. over the protective cover,
central to the cleaning motor)
6
Manually slide the lifting device (3) to the top lift position and hold it in this position
7
Manually slide the cleaning motor (4) with cleaning cutter into the cleaning position
-
see detail (5) for welding torches with insulating sleeve
- see detail (6) for welding torches with spatter guard
NOTE!
The cleaning cutter must not come into contact with the welding torch parts.
8
Mount the cleaning motor (4) in this position in the lifting device (3) - tighten the
screw (2) on the lifting device
9
Perform a function test with the gas nozzle removed: Manually slide the cleaning
motor into the top position
-
The cleaning cutter must surround the contact tip without colliding with it.
If the cleaning cutter is in contact with welding torch parts, adjust the position of
the cleaning motor
10
Fit the gas nozzle onto the torch body
11
Perform a function test with the gas nozzle fitted: Manually slide the cleaning motor
into the top position
-
The cleaning cutter must plunge into the gas nozzle without colliding with it.
If the cleaning cutter is in contact with welding torch parts, adjust the position of
the cleaning motor
12
Mount the protective cover on the cleaning device so that it is in its original position
36