Fronius DeltaSpot, Operating Instructions/Spare Parts List

Page: 63 / 84

61
EN
Replace wearing parts
General
Instructions for
storing and load-
ing process tapes To guarantee that the process tapes remain in top quality condition, please note the follow-
ing recommended environmental conditions for storage:
-
Store process tapes only in the original packaging (vacuum packed)
- The temperature in the storage location should not exceed 35°C (95°F)
When loading a new process tape note the following:
-
Do not remove process tapes from their packaging until they are required
- Wear oil and grease free gloves
- Dust and dirt free environment
- Do not touch adhesion points
* aluminium side
Load new proc-
ess tape
WARNING! Work that is carried out incorrectly can cause serious injury or dam-
age. All work must be carried out by trained and qualified personnel in compliance
with the relevant safety regulations. Note the safety rules in the operating instruc-
tions.
IMPORTANT! Check electrodes for wear and replace if necessary each time a new proc-
ess tape is loaded.
Material Process tape Tape ma-
terial Heat input from
exterior sur-
roundings Process
tape length
Deep drawn steel, ungalva-
nised
Deep drawn steel galva-
nised
CrNi PT 2000 Copper low 52 m (174 ft.)
High-strength and ultra-
strong steel, drill steel PT 1205
PT 2000
PT 2110 Steel
Copper
Copper medium
low
low 70 m (230 ft.)
52 m (174 ft.)
52 m (174 ft.)
AI 99
AIMg3
AIMg5 PT 1407 Steel medium 70 m (230 ft.)
AIMgSi PT 1200 Steel medium 70 m (230 ft.)
Steel / aluminium PT 3000* CrNi high 52 m (174 ft.)
CAUTION! Risk of injury from springiness of spooled process tape. To avoid in-
juries caused by the process tape springing back, hold the end of the tape firmly
when fitting it.
CAUTION! Danger of injury from sharp-edged process tape. Wear safety gloves
when working with process tape.