Fronius DeltaSpot, Operating Instructions/Spare Parts List

Page: 43 / 84

41
EN
Connect the digital signal cable from the power source (4) to the digital power source
connector (X4) (connection for power source: see "Connecting Bosch PSI 6xxx.000
power source")
Connect the signal cable from the hall installation panel (6) to the coolant flow control-
ler connector (X3)
Connect the external Emergency Stop signal cable from the robot (8) to the external
Emergency Stop connector (X2)
If applicable, connect the external welding start-up connection cable (5) to the external
welding start-up connector (X5)
Connect to the industrial PC (9) via the CAN1 communication interface
Connect the spot welding gun motor controllers (10) via the CAN2 communication in-
terface
Connecting the
spot welding gun
Connecting the spot welding gun
Establish a CAN connection between
the PC and the CAN connector (1)
Plug DeltaSpot welding gun (2) main
connector into connection X1.1
Flow controller connection, upper,
lower gun arm and welding transformer
Connecting the
cooling water
supply
Connect cooling water flow and return to the distributor block on the spot welding gun
Connect cooling water supply
Connecting
Bosch PSI
6xxx.000 power
source Connect cables X4 and X6 from DeltaControl to the power source according to wiring
diagram
WARNING! Incorrect operation may result in serious injury or damage. The de-
sign of external operating equipment or Emergency Stop actuators must comply
with valid national and international standards.
3
4
5
6
7
8
(1)
(2)
(3)
1
2
3
NOTE! Inadequate cooling can cause damage to property. Never operate weld-
ing plant without adequate cooling. The manufacturer shall not be liable for dam-
age caused by inadequate cooling.
1
2
1