Fromm FS380, Use And Maintenance Manual, Page: 88 / 100

82
Rev.2 01/03/2021
Use and Maintenance Manual | TURNTABLE - MAST
82
6.2 INSTRUCTIONS FOR USE
6.2.1 LOADING A ROLL OF FILM
6.2.2 STARTING THE MACHINE
A) Correctly place the pallet on the turntable (5) ;
B) check that there is a roll of film (3) on the roll-holder shaft (4) and
check that the film is correctly routed according to the diagram
(see plate (6) indicated for the carriage (1) being used;
C) turn ON the panel using the main switch (2) and press the reset
button (7) to enable the machine;
D) manually draw out the film protruding from the roll-holder carriage
(1) and attach it to a corner of the pallet;
E) set the operating cycle from the control panel
F) press the START button (A) on the operator terminal;
G) After wrapping, manually cut the film and fix it to the pallet;
H) the pallet can now be unloaded.
»
See Picture 60 - pag. 83
This is a general procedure.
Carriage-specific operations are described in the relative roll-holder carriage
manual.
A) Lower the roll-holder carriage (1) to make it easier to load the roll;
B) turn the main switch (2) to ‘O’-OFF ;
C) open the carriage door (depending on the carriage model);
D) push the roll (3) onto the carriage pin (4) ;
E) unwrap the film and thread it between the rollers;
F) close the carriage door.
»
See Picture 60 - pag. 83