REMOVAL AND REPLACEMENT OF PARTS
Page 29
Service Manual TDR8 P Gas form 9124023 rev. 01/2022
Before changing the CPU board and display be
sure to download (with a USB stick) or write
down the grilling programs and the parame
ters.
1. Remove the right side panel according
prior procedure.
2. Remove the operating panel according
prior procedure.
3. Remove the 4 nuts and rings on the CPU
board and remove the board.
4. Reverse the procedure to install.
5. Read the grilling programs and parameters
from the USB stick to the CPU board.
Note 1:
Flatcable keypad must be connected
to connector “Touchpanel 1” on CPU board.
Note 2:
“Touchpanel 2” is flatcable connection
for the rotor switch keypad on customer side.
Note 3:
For older units with earth wire in
right hand bottom corner. Take care that the
ring terminal doesn’t make contact with with
the solder point (see arrow) .Otherwise the il-
lumination of the display and keys can be out.
CPU BOARD
POWER AND I/O BOARD
1. Remove the right side panel according
prior procedure.
2. Disconnect the wiring and flatcable on the
board.
3. Remove the board from the clips by pìn-
ching the clips.
4. Reverse the procedure to install.
