Fri-Jado Deli Multisserie, Service Manual

Page: 40 / 132

REMOVAL AND REPLACEMENT OF PARTS
Page 40
Service Manual Deli Multisserie form 9123667 rev. 20220317
1/4”BSPp 1/8”BSPp
9191234
1 1
22
33
44
88
EXCHANGING THE SIDE POST PIPE AND SPRAYERS
Disassembling the pipe and sprayers.
1. Remove the 3 sprayers [210] including the
nipple adapters [209] from the inside.
Wrench size metric 24.
2. Open the top of the unit. 9 screws
3. Loosen the hoseclamp and take off the
hose. Socket size 7mm
4. Take the pipe out of the side post.
5. Clean the pipe and the thread holes in case
it will be reused.
6. Also clean the holes in the sidepost.
Assembling the pipe and side post sprayers.
1. Make a mixture of the 2 component
sealant. This is 1cc of resin and 8 drops of
hardener for each sprayer.
2. Put the sprayer pipe from the top into the
sidepost.
3. Apply a general amount of mixture on the
outside thread of the nipple adapter.
4. Lift up the pipe, line up the middle hole
and mount a nipple adapter in this hole,
handtight.
5. Repeat from step 3 for the other two nip-
ple adapters.
6. Tighten the nipple adapters with a torque
of (20 Nm). Use a 24 mm wrench.
7. Remove the redundant sealant.
8. Mount the hose to the pipe at the top.
Note that units untill serial number
100046244 (July 2009) can have the old
sprayers with seal ring. These must be
replaced by the above mentioned nipple
adapter and sprayer. Thoroughly clean the
pipe thread and holes in the sidepost !!
CLEAN !
OLD !!