Fri-Jado Deli Multisserie, Service Manual

Page: 52 / 132

REMOVAL AND REPLACEMENT OF PARTS
Page 52
Service Manual Deli Multisserie form 9123667 rev. 20220317
3 3
55
22
66
or
√
7 7
EXCHANGING THE DOORS AND DOOR PARTS
1. Open the door.
2. Open the inner door by pulling it from the
outer door at the top.
3. Lift the inner door ± 1 inch and pull it out
of the outer door. The weight is 8,5kg
4. Put the inner door on a safe place. Put
some carton under it when placing it on
the floor. Make sure that it cannot slide
away and fall!!
5. Loosen the top hinge bolt with a 17mm
wrench.
6. Take the outer door with the left hand at
the hinge side, lift a little to release the
bolt and pull out the hinge bolt.
7. Take the door with the right hand at the
bottom side, lower the left hand a little
and lift the door from the lower hinge.
The weight is 15kg!
8. Put the outer door on a safe place. Put
some carton under it when placing it on
the floor. Make sure that it cannot slide
away and fall!!
Note that it is possible to take out the com-
plete assembly of outer and inner door in
one time.
This is of course much heavier.
Total weight is 23,5kg ! Therefore it is
advised to do that with 2 persons. In this
case it is possible to skip #2, 3 and 4.
Reverse the procedure to hang in the doors.
Adjusting the outer doors.
Step 1.
• Loosen the bolts of the top hinge of the
left door, slide the hinge to the right as
far as possible and fasten the bolts again.
• Do the same with the bottom hinge.
Step 1 Step 2 Step 3
Adjusting the outer door.
Check
clearance