Fri-Jado Deli Multisserie, Service Manual

Page: 46 / 132

REMOVAL AND REPLACEMENT OF PARTS
Page 46
Service Manual Deli Multisserie form 9123667 rev. 20220317
11
22
33
44 55 66
88 99
1. Open the top to gain access to the wiring.
Core probe.
2. Disconnect the 2 wires from the sliding
ring.
3. Unscrew the core probe (17mm Wrench).
• Reverse the procedure to mount. Do not
put too much force on the 17mm bolt! it
is hollow and therefore weaker !
• Check the adjustment of the sliding ring
and contacts. The 3 arrows point at places
where 1-2 mm clearance should be ob-
served. It is also very important that the
sliding ring is mounted in the middle of
the contacts. See side view detail. Note
that the contacts differ in lenght. On the
left side, the bottom contact is longer
than the top one! On the right side it is
shorter!
Top sensor.
4. Remove some insulation at the top.
5. Unscrew the nut with a 15mm wrench and
hold the sensor at the inside with a 13mm
wrench.
6. Take the sensor protection from the sensor
and take out the sensor..
7. See point 14 below for the wiring.
Reverse the procedure to mount.
Bottom sensor.
8. Unscrew the sensor with a 13mm wrench
and take off the sensor protection.
9. Cut the wire.
EXCHANGING THE PT1000 TEMPERATURE SENSORS
side view detail Take care of clearences!!
Top sensor Top sensor
Bottom sensor Bottom sensor