Note:
if the version of the machine does not have the
shaft locking system as described (the case of the first
series manufactured), the saw blade must be blocked
using a bar or a screwdriver in the hole of the saw blade,
leaning against the firm structure of the machine.
2. REPLACING THE BRUSHES
The brushes must be replaced after every 150 - 200
hours of use or when they have reached a length of 5-6
mm. Go to an authorised service centre for this change.
3. REPLACING THE SUPPLY CORD
Z2
(Fig.7)
Make sure that the supply cable is in a good state and if
not, go to an authorised service centre for it to be
changed.
GUARANTEE
See general Guarantee conditions printed on an adjoin-
ing sheet.
DECLARATION OF CONFORMITY
We hereby declare, under our own responsibility,
that the
FREUD
products described in this manual
FTR250 and FTR250T comply with the following
standards or standard documents: EN 61029-1,
EN 55014 and EN 61300-3 in accordance with EU
Directives 73/23/EEC, 89/336/EEC, 98/37/EEC
and 2002/95/EEC.
05
Ernest
Casals
Laboratory Mgr.
José Ramón Córdoba
Plant Mgr.
Talleres Casals, S.A. Ripoll (Spain) 02/2005
We reserve the right to make technical changes
