Set Up with Tool Suite
FGRIO Master–
In order for the FGRIO System to function properly, the following settings
must be programmed. For all other settings not listed below, please refer to the User Manual.
0) Set Operation Mode Tab-
(Figure 13)
Point to MultiPoint Slave
– Choose this setting when the FGRIO System is being inte-
grated into an FGR FreeWave Network. The IO functionality is turned on under the IO Set-
tings tab.
Note:
Setting
(E), FGRIO Master
, should only be selected when the FGRIO System is operating inde-
pendently of an FGR FreeWave Network.
Figure 13
2) Call Book Tab-
Enter the serial number for each IO Slave, for a maximum of up to four (4) IO-Slave Ra-
dios.
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-20028-FreeWave-FGR2-IO-IOE-Radio-Enclosed-900-MHz-I/O-Slave-Radio.aspx
