When I try to Braille a document, all I get is speech from the
Blazer.
Enter menu mode and go into the Speech Configuration menu,
enter the options for changing the port, and cycle to Off. Then
exit menu mode and try sending your document to the Blazer
again.
When I try to Braille a document from my Braille n speak, Type
n Speak, or Braille Lite with the Blazer, the formatting is wrong.
It's best to let your notetaker format your document rather than
the Blazer. So make sure the following format parameters on
the Blazer are set properly from within the Printer Configuration
menu.
Left margin = 0
Right margin = 34
Top margin = 0
Lines per page = 0
Word wrap = Off 5.
I'm trying to use the Blazer as a speech synthesizer with my
computer, but it doesn't talk.
There are several possibilities to consider:
•
Make sure the connection between your computer and the
Blazer is working properly.
•
Check that the serial port on the Blazer is active from within
the Speech Configuration menu.
•
If you're using a "straight-through" cable between the Blazer
and the other device, you may need to use a null modem
cable for the transmission to work properly.
•
Make sure the screen access program you're trying to use
supports the Braille n speak as a speech synthesizer, that
you've properly installed the Braille n speak driver on your
440102-001 Rev. A
41
