Changing the Direction of Paper Feed
Enter the Printer configuration menu. Press Skip once to move
to the "Paper feed" setting. The Blazer should say, "Paper feed,
pulling active", which is the default. This means that the Blazer
will pull the paper from the front of the Blazer toward the back.
This it is the preferred direction for feeding paper through the
Blazer to prevent the paper from jamming.
However, if you want to try saving paper, you can avoid wasting
the first sheet of paper that is fed through the Blazer by
reversing the direction of paper feed.
Since the only two options for Paper Feed are "Pulling" and
Push out", you can toggle between them by pressing Enter.
Adjusting the Margins
The next four settings on the Printer Configuration menu are for
adjusting the margins. Although this menu lets you adjust the
left, right, and top margins of your document on the Blazer, it no
longer lets you adjust the bottom margin.
It's usually better to adjust margins from within your word
processor. But if you do want to adjust the margins from the
Blazer side of things, here's how it works.
When you enter the Printer Configuration menu, navigate to the
margin setting you want to adjust by pressing Skip (the middle
key) and Back (the key furthest away from you) until you arrive
at your choice. Then press Enter to cycle through that setting's
options. Your change takes effect when you move to another
setting, move to another menu, or exit menu mode altogether.
Setting the left margin: When you enter the Printer
Configuration menu, press Skip twice to arrive at the first of the
margin settings, Left Margin. The Blazer says, "Left margin 0,
active", which is the default. This is literally the left edge of the
paper.
To change the left margin, press Enter. The Blazer lets you
adjust the left margin up to 10 spaces from the left edge of the
paper before it cycles you back to 0.
26
440102-001 Rev. A
