F3D3
Series
Service Manual Parts Replacement / Section 2.4
Questions? Call Franke Technical Support Group For Your Area. Copyright
2012 Franke, Inc. All rights reserved.
2.4
Door Lift Slide Replacement
1)
Roll the unit out to allow access to rear service panel.
2)
Disconnect power at outlet. [Pull plug.]
3)
Remove the screws securing rear service access panel.
Lift panel up and off.
4)
Detach the Black and Red electric power connections
from the Slide Lift and Door Open Motors.
5)
Straighten, remove and save the cotter pin that secures
the spring (with bushing) to the (left) Door Rotation Block
Pin. Carefully release tension on spring, slide off bronze
end bushing and allow spring to hang from the right side
spring mounting screw.
6)
Remove the retaining clip from the right side of the white
plastic Door Cam Link. Remove that link.
7)
From the front side - hinge up silicon rubber fries bucket,
then rotate product doors down to expose the shaft
mounting screws on both doors.
8)
Using a 3 mm [1/8”] Allen/hex wrench, remove the three
screws that attach each door to its pivot shaft.
9)
Slide the rubber fries bucket off the left door shaft.
10) Remove the rubber seal cover from both Door Shafts.
11) Using a 4 mm [5/32”] Allen/hex wrench, remove the four
Door Open Motor mounting screws. Removing the two
top screws will separate the Door Open Sensor &
Bracket from the motor assembly. It can hang down from
cable. [
NOTE:
Top screws are 5 mm longer than bottom
screws and should be kept separate until reinstalled.]
12) Using the 4 mm [5/32”] Allen/hex wrench, remove the
four Door Lift Motor mounting screws. [Bottom motor]
13) Carefully remove the motor and gearbox assembly from
the machined aluminum Door Slide Lift Assembly.
14) Remove the Door Lift Shaft from the Slide Bearing
Assembly.
15) Using a 6 mm [¼”] Allen/hex wrench, remove the four
Door Lift Slide mounting bolts.
16) Pull Door Lift Slide sub-assembly [with shafts] out of
cabinet and place on a convenient work surface.
17) Using a ’C’ ring pliers, remove both retaining rings on the
freezer side of each door mounting shaft. [
IMPORTANT:
Back retaining ring on each shaft should stay in place.]
18) Using a rubber mallet, tap door shafts out of Door Lift
Slide bearings.
19) Take the replacement Door Lift Slide and use your
rubber mallet to tap door shafts back into place.
20) Replace the two ‘C’ Rings on each shaft.
…Continued
[Photo 1] From Rear
Remove the cotter pin retainer
from left side door rotation block
pin then relieve spring tension.
[Photo 2] From front
Hinge up rubber hopper, open
load doors and remove three
shaft-mounting screws on each
.
[Photo 3] From rear
Remove the four motor mounting
screws from the Door Lift Motor.
.
Tools Required:
Medium Phillips
screwdriver
3 mm [1/8”], 4 mm [5/32”]
& 6 mm [¼”] Allen/hex
wrenches
‘C’ ring pliers
Rubber mallet
Needle-nose pliers
