F3D3
Series
Service Manual Parts Replacement / Section 2.9
Questions? Call Franke Technical Support Group For Your Area. Copyright
2012 Franke, Inc. All rights reserved.
2.9 Product Door & Bucket Replacement
[See Section 1.5 for Part Number]
1)
Roll the unit out to allow access to rear service panel.
2)
Disconnect power at outlet. [Pull plug.]
3)
Remove the screws securing rear service access
panel. Lift panel up and off.
4)
Straighten, remove and save the cotter pin that
secures the spring (with bushing) to the (left) Door
Rotation Block Pin. Carefully release tension on spring,
slide off bronze end bushing and allow spring to hang
from the right side spring mounting screw.
5)
Remove the hopper and plastic freezer bottom from the
refrigeration compartment to provide access to the
product dispensing doors. [See Photo 2]
For Replacement of Product Doors:
6)
Hinge silicone rubber bucket up and off right door
shaft.
7)
Rotate product doors down to expose the shaft
mounting screws on both doors. [See Photo 4]
8)
Using a 3 mm [1/8”] Allen/hex wrench, remove the
three screws that attach each door to its pivot shaft.
9)
If rubber fries bucket is OK, attach new doors [two ea.
P/N: 19003534] to shafts using socket-head screws
removed previously.
NOTE:
Both doors are the same
and are rotated 180-degrees, for left or right installation
–
but there is a top and bottom
. The ‘
V
’ groove
should face the floor on both right and left door.
For Replacement of Product Bucket ONLY:
10) Hinge silicone rubber bucket up and off right door
shaft.
11) Using a 3 mm [1/8”] Allen/hex wrench, remove the
three screws that attach the left side door only.
12) Deform and slide the rubber fries bucket off the
right/left door shaft.
13) Install the new rubber fries bucket [P/N: 19002725].
14) Replace the left door using the three M5 x 20 socket-
head screws just removed.
With either Replacement:
15) Hinge rubber fries bucket down and snap over right
door shaft. Bucket and doors should be square, without
any gaps. [See Photo 2]
[Photo 1] – From rear
Remove the cotter pin retainer
from left side door rotation block
pin then relieve spring tension.
[Photo 2] – From unit front
Remove fries bin & freezer bottom
to access bucket & doors.
[Photo 3
]
Hinge bucket up & off right door
mounting shaft.
[Photo 4]
– To remove door:
Rotate door down & remove
three mounting screws using 3
mm [1/8”] hex wrench.
