F3D3
Series
Service Manual Parts Replacement / Section 2.23
For Technical Support, Call 800-537-2653. Copyright
2012 Franke, Inc. All rights reserved.
2.23 Power Cord Replacement…Continued
18) From rear of unit – slide strain relief down on to threaded
grommet and tighten to secure power cord.
19) Position and secure rear service access panel and return
Dispenser to normal operating position.
Test
Operation of new Power Cord:
22) Plug new power cord into power source.
23) Turn ON main power switch. Pilot light should come on,
and after a delay, the compressor should start and run.
[Photo 5]
Pull out power cord from right
plastic tubing then up through
grommet in condenser
compartment bottom.
Rev. 1 6/2012
Tools Required:
Medium Phillips screwdriver
Pliers or channel locks
10 mm [3/8”] wrench
Electric tape
