F3D3
Series
Service Manual Component Adjustments / Section 3.3
Questions? Call Franke Technical Support Group For Your Area. Copyright
2012 Franke, Inc. All rights reserved.
3.3 Adjusting Automation Assy. Alignment
Problem:
Silicone rubber
Product Dispense Bucket does not
align with or seal against rectangular opening in the
removable freezer compartment bottom.
1)
The Dispenser should be OFF and the freezer
compartment fully defrosted before proceeding.
2)
If not already removed, open freezer compartment door
and remove the Fry Hopper.
3)
Roll the unit out to allow access to rear service panel.
4)
Disconnect power at outlet. [Pull plug.]
5)
Remove four Phillips screws securing back service
access panel. Lift panel up and off.
6)
Using a 10 mm box wrench, barely loosen all eight [M6]
Automation Assembly mounting bolts. This assembly
attaches to the rear frame with right and left ‘
L
’ channels.
Bolt holes in the ‘L’ channels are all slotted to provide in-
out or up-down adjustment of the Automation Assembly.
7)
Minimally tighten the four channel-to-Automation
Assembly bolts and manually position and level
assembly front-to-back, so the product loading doors and
bucket are centered in freezer bottom opening. [
NOTE:
Check this alignment from front of unit.]
8)
Minimally tighten the four ‘L’ channel-to-rear-frame
mounting bolts and adjust height of the Automation
Assembly so that the dispenser doors just “kiss” the
freezer bottom. [Check this alignment from front of unit.]
9)
Tighten all eight M6 bolts securely and recheck dispense
door-to-freezer bottom seal and fit. If further adjustment
is required, repeat steps 6 through 9.
10) Replace and secure rear service access panel.
11) Plug in unit power cord to power supply.
12) Move unit back into operating position and lock casters.
13) Re-install the Fry Hopper.
Test
Automation Assembly alignment:
14) Turn ON main power switch and press Lane-POWER
touch pad.
15) When word:
Ready
appears in display and basket
graphic lights are on, position an empty fry basket in fill
lane and press against basket bump-switch to initiate
fries loading cycle.
16) Check gap between silicone rubber dispense bucket and
freezer compartment bottom with a business card, from
inside the freezer. There should be a snug fit, bucket-to-
bottom.
[Photo 1] F3D3S from front
Product bucket & dispenser
doors must be centered in and
seal against freezer bottom.
[Photo 2] From back of unit
Loosen four assembly-to-side ‘L’
channel mounting [M6] nuts to
adjust front-to-back position and
level of door frame.
[Photo 3] From back of unit
Loosen four ‘L’ channel-to-frame
mounting nuts to adjust height
and seal of Door Lift Assembly.
Rev. 1 6/2012
Tools Required:
Medium Phillips screwdriver
10 mm box wrench
