29
ENGLISH
5.2 COUNTRY SETTINGS MENU
By means of the SETTING COUNTRY menu, it is possible to set the canalization of the selected country. The
available canalizations are Europe, France, UK and Australia.
5.3 FILTERS MENU
SETTINGS
FILTERS
FILTERS
<XXXXXXXXXX> 01
FILTERS
<XXXXXXXXXX> 02
Changing
filter
Programming filter
number 01
Programming
filter number 02
FILTER1
SET. INPUT
SET. INPUT
INPUT 1
To enter a value
To increase/ decrease
the value
INPUT 1
INPUT 2*
INPUT 3*
-4 → -500KHz
-3 → -375KHz
-2 → -250KHz
-1 → -125KHz
+0 → Original freq.
+1 → +125KHz …
+4 → +500MHz
OFF (default,
channel OFF)
0
….
9
AUTO
* Available if the input is
selectable (see fig 2.1 and 2.2)
E21
E22
…
E69
To select
FILTER1
INPUT FREQ.
FILTER1
OUTPUT FREQ.
FILTER1
OUTPUT CH.
FILTER1
INPUT CH.
FILTER1
IF OFFSET
FILTER1
CH. LEVEL
OUTPUT FREQ.
474.00
OUTPUT CH.
E21
INPUT CH.
E21
IF OFFSET
+0
CH. LEVEL
OFF
INPUT FREQ.
474.00
To increase/ decrease
the value
To enter a value
To increase/ decrease
the value
470 MHz
471 MHz
…
862 MHz
E21
E22
…
E69
To increase/ decrease
the value
To increase/ decrease
the value
To increase/ decrease
the value
To select
To select
To select
To select
To select
To select
NOTE: the SAF-HD 7 models provides 7 fi lters.
The fi lters are programmed within the “FILTERS” menu. Each fi lter must be programmed individually by
setting the following: input associated with the fi lter, frequency or channel to fi lter, frequency or output
channel, offset and output level.
Entering the “FILTERS” menu, the following will appear:
FILTERS
<XXXXXXXXXX> --
}
Show 10 fi lters in SAF-HD
X: fi lter off (fi lter level is OFF);
if the fi lter is on (fi lter level different from OFF):
1: fi lter associated to the UHF1 input;
2: fi lter associated to the UHF2 input;
3: fi lter associated to the UHF3 input;
To select the fi lter to be programmed, use the left/right arrows and press
to enter the programming of the
selected fi lter.
From this menu, it will be possible to select the channel to fi lter (by frequency or channel number), as well as
to select the output channel (by frequency or channel number), to set the OFFSET (by steps of 125KHz) and
to set the channel output level.
FILTERS E32 - E21
<
1
XXXXXXXXX> 01
Input channel fi ltred *
Output channel (converted)*
Indication of the number of
fi lters you are programming
The selected fi lter fl ashes
* if the fi lter is
enabled
NOTES
:
•
All fi lters are OFF by default. To enable them, set the channel output level (by default, it is OFF).
•
After setting the fi lter level to AUTO, start the AUTOMATIC EQUALIZATION from the EQUALIZATION
menu.
5.4 EQUALIZATION SETTINGS MENU
RF EQUALIZE
SETTINGS
FILTERS
<989A999999> 02
RF EQUALIZE
MANUAL
RF EQUALIZE
AUTO
ATTENTION
V=Start-up
MANUAL
<989A999999> 01
To confirm
Execute the automatic
equalisation of the filtered channels
0
…
9
A