RIPng
341
[no] IPv6 router rip
Configure the interface to run RIPng protocol;
the
no IPv6 router rip
command set the
interface not run RIPng protocol.
2. Configure RIPng protocol parameters
（
1
）
Configure RIPng sending mechanism
1
）
Configure the RIPng data packets point-transmitting
Command
Explanation
Router configuration mode
[no]
neighbor
<IPv6-address>
<ifname>
Specify the IPv6 Link-local address and
interface of the neighboring route needs
point-transmitting;
the
no
neighbor
<IPv6-address> <ifname>
command cancels
the appointed router.
[no] passive-interface
<ifname>
Block the RIPng multicast on specified port
and the RIPng data packet is only
transmittable
among
Layer
3
switch
configured
with
neighbor.
The
no
passive-interface
<ifname>
command
cancels the function.
（
2
）
Configure RIP routing parameters
1
）
Configure route introduction (default route metric, configure routes of the other
protocols to be introduced in RIP)
Command
Explanation
Router configuration mode
default-metric
<value>
no default-metric
Configure the default metric of distributed
route; the
no default-metric
command
restores the default configuration 1.
[no]redistribute
{kernel
|connected| static| ospf| isis| bgp}
[metric<
value
>]
[route-map
<word>
]
Redistribute the routes distributed in other
route protocols into the RIPng data packet;
the
no redistribute {kernel |connected|
static| ospf| isis| bgp} [metric<
value
>]
[route-map
<word>
]
command cancels the
distributed route of corresponding protocols.
[no]default-information originate
Generate a default route to the RIPng
protocol;
the
no
default-information
originate
command cancels the feature.