55
configured, its configuration will be applied when sending the RMON trap. This command
allows configuration the IPv4 or IPv6 address of the network manage station receiving the
SNMP Trap message, but configure the version number as v1 and v2c of the IPv4 and
IPv6 address are less than 8 in all.
Example:
Configure an IP address to receive Trap
Switch(config)#snmp-server host 1.1.1.5 v1 usertrap
Delete a Trap receiving IPv6 address
Switch(config)#no snmp-server host 2001:1:2:3::1 v1 usertrap
1.4.17 snmp-server securityip
Command: snmp-server securityip {<
ipv4-address> | <ipv6-address>
}
no snmp-server
securityip {<
ipv4-address
>
| <ipv6-address>
}
Function:
Configure to permit to access security IPv4 or IPv6 address of the switch NMS
administration station;
the no command deletes configured security IPv4 or IPv6 address.
Command Mode:
Global Mode.
Parameter:
<ipv4-address> is NMS security IPv4 address, point separated decimal
format.
<ipv6-address> is NMS
security IPv6 address, colon separated hex format.
Usage Guide:
It is only the consistency between NMS administration station IPv4 or IPv6
address and security IPv4 or IPv6 address configured by the command, so it send SNMP
packet could be processed by switch, the command only applies to SNMP. Allows
configuration the IPv4 or IPv6 address of the network manage station receiving the SNMP
Trap message, but the IP addresses are less than 6 in all.
Example:
Configure security IP address of NMS administration station
Switch(config)#snmp-server securityip 1.1.1.5
Delete security IPv6 address
Switch(config)#no snmp-server securityip 2001::1
1.4.18 snmp-server securityip
Command:
snmp-server securityip {enable | disable}
Function:
Enable/disable the safety IP address authentication on NMS manage station.
Command Mode:
Global Mode
Default:
Enable the safety IP address authentication function.
Summary of Contents for S6124
Page 311: ...311 Machine...
Page 314: ...314...
