FoxGate S6124, Command Manual

Page: 267 / 391

267
Function: Configure number of groups the MLD snooping can join and the maximum
number of sources in each group.
Parameter: vlan-id : VLAN ID, the valid range is <1-4094>
g_limit: <1-65535>, max number of groups joined
s_limit: <1-65535>, max number of source entries in each group, consisting of
include source and exclude source
Command Mode: Global Mode
Default: Maximum 50 groups by default, with each group capable with 40 source entries.
Usage Guide: When number of joined group reaches the limit, new group requesting for
joining in will be rejected for preventing hostile attacks. To use this command, MLD
snooping must be enabled on VLAN
. The ―no‖ form of this command restores the default
other than set to ―no limit‖. For the safety considerations, this command will not be
configured to ―no limit‖. It is recommended to use default value and if layer 3 MLD is in
operation, please make this configuration in accordance with the MLD configuration as
possible.
Example: Switch(config)#ipv6 mld snooping vlan 2 limit group 300
25.1.9 ipv6 mld snooping vlan mrouter-port interface
Command: ipv6 mld snooping vlan < vlan-id > mrouter-port interface
[< ethernet >|< port-channel >] < ifname >
no ipv6 mld snooping vlan < vlan-id > mrouter-port interface
[< ethernet >|< port-channel >] < ifname >
Function: Set the static mrouter port of the VLAN
; the ―no‖ form of this command cancels
the configuration.
Parameter: vlan-id : VLAN id, the valid range is<1-4094>
Ehternet : name of Ethernet port
Ifname : Name of interface
port-channel : port aggregate
Command Mode: Global Mode
Default:
When a port is made static and dynamic mrouter port at the same time, it‘s the
static mrouter properties is preferred. Deleting the static mrouter port can only be done
with the ―no‖ form of this command.
Example: Switch(config)#ipv6 mld snooping vlan 2 mrouter-port interface ethernet1/13
25.1.10 ipv6 mld snooping vlan mrpt
Command: ipv6 mld snooping vlan < vlan-id > mrpt < value >