PATIO COVER INSTRUCTION SHEETS
PATIO COVER INSTRUCTION SHEETS
C
D
E
F
G
Having the
Next Panel Unwrapped… repeat Step 4-E&F
Keep ROOF PANEL 4" away from first panel
and slide it all the way into the ROOF HEADER
Person #1 stands by the first post to hold it steady
while
person #2 is on ladder chest
high with roof panel.
Person #2 counts "1,2,3 PUSH" then
Pushes the Roof Panel
"medium Hard"
to lock into the first panel…person #1 will be bracing the post for the impact of the panels locking
together
Look at the Bottom Seam
of the two locked panels … up to a
1/8" Seam Gap is Normal
.
If the Gap is larger, then
carefully push
the panel more…. to close the seam tighter.
BE CAREFUL not to dent
the panel when pushing…
NOTE: CHECK EVERY SEAM AFTER PANELS ARE LOCKED BEFORE FASTENEING
Then
Fasten through Top of Roof Header downward
into the panel with one #10 tek screw
keeping
4 inches away from the male panel edge
&
1inch back from the front edge of Roof
Header Leg
Person #1
checks FIRST Post SIDES to be Plumb Level
then person #2 Uses a hammer to tap a 5"
long Tek screw with washer through the top of roof panel until it hits the beam…STAY 4 INCHES
AWAY FROM MALE EDGE...
Fasten the 5" screw into beam
until washer hits top side of panel. DO
NOT fasten too tightly as it will interfere with the next roof panel locking into it.
NOTE:THE SQUARE DOES NOT NEED TO BE USED ANYMORE. AFTER EVERY OTHER
ROOF PANEL IS FASTENED, CHECK A POST TO BE PLUMB LEVEL ON THE SIDE OF THE
POST
(not the front or back)…
IF NEEDED GIVE THE POST & BEAM ASSEMBLY A PUSH IN
THE NEEDED DIRECTION TO GET THE POST PLUMB LEVEL.
REPEAT STEPS 5-A,B,C,D,E,F until there is one roof panel left
to put up.
LifeRoom ONE Installation Guide
