PATIO COVER INSTRUCTION SHEETS
PATIO COVER INSTRUCTION SHEETS
Make sure to have 2 screws within 4" of each end of the Roof Header
If mounting to House wall OPTION #2 or #3,
After predrilling and caulking the
Roof
Header(#B)
, Set the Roof Header against the
Wall and fasten using the #12x3" sms screws
thru the wall into the wall studs. Go back and
predrill a second 3/16" hole that will line up to
hit the wall studs. Fasten to the wall studs.
After Roof Header is fastened, caulk around all
the screw heads inside the header AND check
top side and caulk spots if it did not squish out
upward behind the Roof Header
H2
G
STEP # 2A : 3" EDGE Single Beam Preparation (#F)
Set two pieces of the
3" Edge Beam (#F)
on a
smooth flat surface (careful not to scratch)
Mark the
Edge Beam Splice (#G)
at 12” & slide
into one Edge Beam (#F) to the 12" mark. Then
slide the second Edge Beam over the splice and
butt up against the first Beam.
Take one
Top Post Bracket (#I)
and center it over
the butt joint of the two
Edge Beams.
Fasten
using
(2)two #14x1-1/4" teks screws
through
the face of the Top Post Bracket, into one Edge
Beam then into the Beam Splice(#G)
A
B
C
LifeRoom ONE Installation Guide
