PATIO COVER INSTRUCTION SHEETS
PATIO COVER INSTRUCTION SHEETS
H
I
J
K
A
B
When there is one roof panel left on ground to put up. STOP.
Unfasten and remove the last panel
On the
HOUSE end of the next ROOF PANEL
, on the
TOP side
,
squeeze out a 1/4" bead of
sealant
on the Aluminum skin
ACROSS the 23" direction
1 inch away from the REAR edge of the
panel
Same as STEP 4E
REPEAT STEPS 5A,B,C,D,E,F
Put up the last ROOF PANEL
&
REPEAT STEPS 5I & J
NOTE:
the last ROOF PANEL, Male Edge might overhang the 3x3 FRONT EDGE BEAM and the
ROOF HEADER slightly…that is OKAY… it will get covered up by the EXTRUDED FASCIA(#E)
Take one piece of
Extruded Gutter(#D)
and the
Gutter Splice(#C).
Measure the
Gutter Splice(#C)
and mark it at 12". Measure inside the Right End of
Extruded Gutter(#D)
12" and mark it.
Hook Tape on Right End
of Extruded Gutter(#D) and
measure to the LEFT
and
mark at 2” &
10"
… then
Measure up 1" from Gutter Bottom and Down 1" from the TOP. Make the 4 Marks
for Splice Screw
Locations
Use sealant in the bottom corners of the Gutter, zig zag
across the bottom, the gutter front and
back to the 12"mark …
stay 1" away from RIGHT Gutter EDGE
Gutter Top View
STEP #6 : Installing Extruded Gutter(#D) A391
LifeRoom ONE Installation Guide
