18
FORTRESSACCENTS INSTALLATION: PLUG AND PLAY
INSTALLATION (METAL POST): LED VERTICAL POST LIGHT
Step 1:
Drill LED Vertical Post Light Wire Hole
1. Place the LED Vertical Post Light Base on the post at the
desired location. The LED Vertical Post Light should be
installed a minimum of 12” [305mm] above ground level.
As shown in Fig. 32.
2. Using a pencil, trace the hole pattern onto the post. As
shown in Fig. 33.
3. Mark the center point of the hole pattern and drill a 1/2”
[13mm] diameter hole in post.
Tip:
• Be sure to remove any metal shavings from the surface of
deck, patio or balcony to prevent rust on the surface.
Fig. 32
Step 2:
Mount LED Vertical Post Light Base
1.
Pre-drill screw holes using a 5/32” [4mm] drill bit.
2. Attach LED Vertical Post Light Base to post with supplied
screws then feed wire through post cutout. As shown in
Fig. 34.
Installed a
Minimum of
12” [305mm]
above ground
Fig. 34
Fig. 33
