_________________________________________________________________________
36
2
Loading Paper
1. Take a stack of printed paper and place it on the feeder table in the desired orientation.
NOTE:
If using sheets longer than 450 mm (17.7”), but shorter than 700 mm (27.6”) extend the built-
in pull-out table. If using sheets longer than 700 mm (27.6”) see the “Feeder Table Extension”
section within this manual.
2. Ensure the paper is pushed into the corner and is aligned to both the
registration wall [A] and the front wall [B].
3. Align the magnetic paper guides [C] with the edges of the paper stack. Ensure the
guides are not too tight and the sheets can move freely.
NOTE:
To make sure the magnetic paper guides are not too tight put a single sheet of paper between
the stack and the guide when setting the guide.
4. Take a single sheet from the stack and use it to set the magnetic stacker guides to this
paper size. Use the lever [D] to raise the stacker guides from the surface to make them
easier to move.
A
C
C
B
D