_________________________________________________________________________
29
1
6. Mount a matching pair of anvils [F] and secure them to the drive wheel using a 2.5 mm
hex key
7. Position the perforation blade [C] using the ruler on the rotary tool carrier. Secure the
drive wheel in place using a 2 mm hex key.
8. Slide the drive hub with the anvil [F] towards the perforation blade until there is a small
clearance (~0.1 mm / 0.004”) and secure it in place using a 2 mm hex key.
NOTE:
Use an 80 gsm sheet of paper to set the 0.1 mm (
0.004”)
gap between the blade and the anvil.
Do not force the blade against the anvil to prevent damage.
9. Place the rotary tool carrier back in the machine and close the top cover.
10. Run a proof sheet and inspect the output.
11. If position adjustment is necessary, repeat steps 7 to 10.
12. If the perforation is skew on the sheet (L1
≠
L2) use the feeder skew adjustment to
correct for this (steps 13 to 16 on the next page).
NOTE:
Changing feeder skew also affects the crease. See “Setting Crease Tilt Knob” section of this
manual to adjust this.
Feed direction
L1: position
L1 – L2: skew
L1
L2