FOR-A FA-10DCCRU, Operation Manual

Page: 281 / 300

265
20-3. AFD Supported Video Formats
FA-9500 supports aspect ratio conversions according to SMPTE S2016-3, SMPTE
RP186-2008VI (Video Index), and ITU-R BT1119.2 WSS(Wide-Screen Signalling) standards.
AFD formats and their supported video formats are as shown in the table below.
Video Formats and AFD Support
Input video format S2016-3
RP186-2008
VI
BT1119.2
WSS
525/60  
625/50   
1080/59.94i 
1080/50i 
1080/23.98PsF 
1080/24PsF 
720/59.94p

720/50p 
1080/59.94p 
1080/50p 
20-4. AFD Based Auto Aspect Conversion Settings
 AFD system settings
To convert aspect ratios according to AFD codes, set basic operational settings in the VIDEO
SYSTEM menus as follows.
 Set ANC MODE to DETAIL in CONV1 ANC SET (Sec. 5-10-9).
 Set ANC MODE to DETAIL also in CONV2 ANC SET (Sec. 5-10-10).
 Specify the line to detect RP186VI or BT1119 WSS in ANC DETELCT LINE (Sec.
5-10-14). The line must be correctly set for RP186VI and BT1119 WSS detection.
S2016-3 data is automatically obtained from input signals. AFD data in S2016-3 is
automatically obtained from the input HD-SDI signals,.
 Select an AFD type to detect for SD-SDI input signals under AFD in ANC DETECT SEL
(Sec. 5-10-15).
 Select the AFD data to insert, and which output to insert the data in ANC DATA EMBED
(Sec. 5-10-16). These settings are necessary when inserting AFD data into video signals
to be output from CONV1 and/or 2.
 To enable devices that receive signals from FA-9500 to detect ancillary data, select the
ancillary data type, output video format/s for CONV1 and/or 2 output/s, and line number
into which the data is to be inserted in the ANC EMBED LINE menu (Sec. 5-10-17). The
default setting should be set to the line number usually used.
 Select the operation mode when AFD input is lost in ANC LOSS SET (Sec. 5-10-18).
 AFD verification
Auto aspect ratio conversion according to AFD data cannot be performed if there is no AFD
data present in the input signal. Whether the AFD data is detected can be verified in AFD IN
STATUS (Sec. 5-13-16), ANC IN STATUS (Sec. 5-14), and ANC IN STATUS1-2 (Sec. 5-15).
P186VI and BT1119 WSS states that appear as
ABSENT indicate the absence of AFD data
that allows for auto conversion. For auto conversions using S2016-3, the data packet must be
detected in the ANC IN STATUS1-2 menu. If no AFD data is detected, reset AFD system
settings. Also, check if any AFD data is being inserted using a waveform monitor.