Fohhn DLI-230, User Manual

Page: 54 / 68

54
Remote monitoring Temperature, Protect, AES/EBU Signals, Power Supply, Fohhn-Net,
Fohhn Audio Soft, Tilt sensor, Pilot tone
Pilot tone monitoring activatable, detectable in Master (on both inputs)
Fault message contact 1 x relay 2 x alternate, 3-pin Phoenix,
Switching contact Load preset, Standby On/Off
Remote control, remote monitoring (DLI-230 ANA)
Remote control Fohhn-Net over RS-485, Fohhn Audio Soft
Remote monitoring Temperature, Protect, Signal, Power Supply, Fohhn-Net, Fohhn Audio
Soft, Tilt sensor, Pilot tone
Pilot tone monitoring activatable, detectable in Master (on both inputs)
Fault message contact 1 x relay 2 x alternate, 3-pin Phoenix,
Switching contact Load preset, Standby On/Off
Remote control, remote monitoring (DLI-230 DAN)
Remote control Fohhn-Net over IP, Fohhn Audio Soft
Remote monitoring Temperature, Protect, Signal, Power Supply, Fohhn-Net, Fohhn Audio
Soft, Tilt sensor, Pilot tone
Pilot tone monitoring activatable, detectable in Master (on both inputs)
Fault message contact -
Switching contact -
Remote control, remote monitoring (DLI-230 OPT)
Remote control Fohhn-Net over IP, Fohhn Audio Soft
Remote monitoring Temperature, Protect, Signal, Power Supply, Fohhn-Net, Fohhn Audio
Soft, Tilt sensor, Pilot tone
Pilot tone monitoring activatable, detectable in Master (on both inputs)
Fault message contact -
Switching contact -
Controllers
Digital Signal Processors 2
Independent Limiters 6
Selective 3-band limiting bass/mid/high
Band-specific time constants yes
Filter technology 80-bit double precision
AD (DLI-130 AES/DAN/OPT) -
AD (DLI-130 ANA) 24 bit / 96 kHz
FIR
yes
Gain -80 dB – +12 dB
Volume -80 dB – +12 dB
EQ input 10 fully parametric filters, Gain +/-12 dB, Frequency 10 Hz – 20 kHz, Q 0.1
– 100
EQ output 10 fully parametric filters, Gain +/-12 dB, Frequency 10 Hz – 20 kHz, Q 0.1
- 100
Limiter / Compressor 2 x Input, 1 x Output
Noise Gate 2 x Input, 1 x Output
X-Over Linkwitz-Riley 4th order, 24 dB / octave, high pass 10 Hz – 20 kHz, low
pass 10 Hz – 20 kHz, 2 x input, 1 x output in each case
Delay input 0.01 – 350 ms or 3.4 mm – 120 m each
Delay output 0.01 – 650 ms or 3.4 mm – 220 m each
Tilt sensor yes
Password protection yes
Auto Power Save adjustable from 1 s to 12 h, or permanently active
User presets 100
Simulation beam Fohhn-Net, Fohhn Audio Soft
Latency (DLI-230 AES) 1.80 ms
Latency (DLI-230 ANA) 2.40 ms
Latency (DLI-230 DAN) Dante + 1.80 ms
Latency (DLI-230 OPT) Op 1.80 ms
Connections (internal) (DLI-130 AES)
Signal inputs 1 x Phoenix 3-pin AES/EBU, 1 x Phoenix 3-pin Fohhn-Net, or 1 x RJ-45
AIREA
Signal link 1 x Phoenix 3-pin, Fohhn-Net
Mains connection 1 x WAGO 2-pin, grounding screwed
Fault message contact 1 x Phoenix 3-pin, 1 x Phoenix 3-pin link
Switching contact 1 x Phoenix 3-pin
Connections (internal) (DLI-230 ANA)
Signal inputs 2 x Phoenix 3-pin analogue, 1 x Phoenix 3-pin Fohhn-Net