Fohhn DLI-230, User Manual

Page: 23 / 68

23
(7) Fault Link
The Phoenix connector can be used as a link.
(8) FOHHN-NET Input
The LFI-350/450 can be connected to the FOHHN-NET remote control network via this 3-pin Phoenix
connector.
(9) FOHHN-NET Link
The Phoenix connector can be used as a link.
(10) receive LED
This LED shows data reception in the LFI-350/450 .
(11) send LED
This LED shows when data is being sent from the LFI-350/450.
(12) Status LED
Using FOHHN AUDIO SOFT, the LFI-350/450 can be switched into Standby Mode. In this mode the
LED turns red:

The amplifiers are switched off.

Power consumption is minimized (economy mode).

The FOHHN-NET remote control network is active.
When the LFI-350/450 is switched on again, the LED turns green.
If the LED is flashing, this indicates a hardware error. In this situation, please contact the FOHHN
Service department: service@fohhn.com
(13) Mains connection
The power supply is connected here. The power supply (with Power Factor Correction) allows a
supply voltage of 100 – 240 V AC / 8 A / 50/60 Hz.