Operating Manual RTM X42.CC Control Center, RTM Monitoring & Control Software
19.03.2019
22
6.4.5
Basic setting — System settings — RTM Brake Control
Figure 14: Basic setting - System settings - RTM Brake Control
In the table " RTM TRANSMITTER / RECEIVER FOR BRAKE CONTROL" you first define the
number and names of the RTM X42 transceivers for the control of the brake actuators.
Additionally, you assign each RTM X42 transceiver module its own IP address and the
number of connected brake actuators.
You can observe that when inserting additional RTM X42 transceivers and increasing
the number of Brake Actuators, the table “BRAKE ACTUATORS” is automatically added
to the corresponding number of rows.
Basic setting — Global settings
Position Description
1
Table “RTM Transceiver for Brake Control”
Name
Enter a unique name
Label
Here you can enter your own label for the component. E.g., a line of
the nameplate or its own name. This information will not be used
otherwise.
IPv4 address
Enter the IP address of the transceiver in the format
XXX.YYY.ZZZ.CCC.
Qty. Brake Actuators
You can observe that the corresponding number of lines is
automatically added to the “Brake Actuators” table when inserting
additional transceivers and increasing the number of Brake Actuators.
2
"Brake actuators" table
RTM Transceiver
Name of the respective RTM transceiver
Name
Enter a unique name for the brake actuator here.
