Operating Manual RTM X42.CC Control Center, RTM Monitoring & Control Software
19.03.2019
10
5
Basic Configuration — Start-Up
5.1
Delivered condition
The system is pre-configured at the factory and adjusted to the installed components.
Telemetry System RTM X42
-
The IP address of the EMGZ482R.Modbus reception module 192.168.0.090
-
Unique radio channel and ID per receiver module
-
Number of Expansion Modules
System Extension RTM X42.CC Control Center
-
IP address of the central computer unit 192.168.0.95 (factory default)
-
MAC address of the central computer unit
-
Unlocked software licenses for ordered software modules
System extension RTM X42.BC brake control (if installed)
-
IP address of the RTM X42.BC.T/R transceiver module(s) 192.168.0.91
-
Radio channel and IDs of the RTM X42.BC.BA brake actuator(s)
The following configurations must be checked locally and adjusted if necessary.
-
Network connection company network
-
Adjustments of the IP addresses (directly on the respective devices)
5.2
Communication settings on system components
5.2.1
IP Address RTM X42 Receiver Module
Preconfigured to: 192.168.0.90
For configurations on the device, refer to the Operating Manual RTM X42.Modbus
5.2.2
IP Address RTM X42 T/R transceiver module
Preconfigured to: 192.168.0.91
For configurations on the device, refer to the Operating Manual RTM X42.BC Brake Control
5.3
Network settings in the FMS Monitoring & Control software
5.3.1
MAC addresses for the central computer unit on the stranding
machine
Data recording during production can only be initiated from one computer. This is the
central computer unit directly located on the stranding machine.
For this purpose, you must enter the MAC address of the central computer unit in the RTM
Monitoring & Control software “Main Computer (control station)”.
Refer to Global settings p. 18ff
As a rule, this is already pre-configured at the factory.
How to verify the MAC address at the RTM X42.CC Control Center
