SET HARDWARE:
Reference: See Section 3.7
Format:
SET HARDWARE [TEXT]
(CR)
Function:
The SET HARDWARE command parallels
the Hardware Setup menu. The user may configure the
input hardware using this command.
The command consists of the word SET HARDWARE, fol-
lowed by the word FLOW, TEMPERATURE or PRES-
SURE, and then by the input characteristics desired. Key
input characteristics are 5V, 10V, 4-20mA, 0-20mA, RTD,
and DIGITAL. (TEMPERATURE ONE or TEMPERA-
TURE TWO needed if Delta Heat)
Note that RTD may be used only on the temperature
input(s), and DIGITAL may be used only on the FLOW
input.
When configuring the flow channel, the (optional) final
word is used to indicate the type of meter being used, and
may be either LINEAR, SIXTEEN POINT or ORIFICE/
PITOT, as required. If this qualifier is omitted, the type
is not changed.
EXAMPLES:
SET HARDWARE Pressure 10V
(CR)
SET HARDWARE Temperature 4-20mA
(CR)
SET HARDWARE Flow Digital
(CR)
SET HARDWARE Flow 4-20 Orifice
(CR)
SET HARDWARE Temperature Two RTD
(CR)
8-8
