FLIR QUASAR CP-3211, User And Installation Manual, Page: 94 / 164

September 12, 2016
86
Configuration and Operation
CP-3211/CP-4221 User and Installation Guide
· Send alarm message by E-Mail – Select whether to send an alarm message by e-mail when
motion is detected.
Note:
Make sure that local recording (with a microSD/SDHC card) is activated so that this function can
be implemented. See
Recording for further details.
·
Upload image by E-Mail – Select this box in order to assign an e-mail address and configure
various parameters. See Figure: Upload Image by E-Mail .
Note:
Images can be sent by e-mail only when MJPEG is selected as the video stream from the Video
Format screen.
When motion is detected, event images are sent to one of two designated e-mail addresses.
Select the number of frames for the pre-trigger and post-trigger buffers from the drop-down menu of
1-20 frames.
Check the box for Continue image upload to use this option. To specify the length of time for the
upload, click this radial button and enter the number of seconds. To upload while the trigger is
active, click this radial button. Finally, select the number of frames per second from the drop-down
menu next to
Image frequency.
Note:
Make sure that SMTP or FTP configuration has been completed. See the Mail and FTP sections
for further details.
File Name
The uploaded image’s filename format is set in this section. Select one that meets your
requirements.Click
Save to save the motion detection settings.