FLIR QUASAR CP-3211, User And Installation Manual, Page: 92 / 164

September 12, 2016
84
Configuration and Operation
CP-3211/CP-4221 User and Installation Guide
If the motion detection function is activated, the following Motion pop-up window appears.
Motion Detection Window without Detection
When motion is detected, the signals are displayed in the Motion window shown below.
Motion Detection Window with Detection
Motion Detection Settings
Settings for motion detection are as follows:
·
Sampling pixel interval [ 1-10] – Select a number from 1-10. The default value is 1. If the value is set
as 3, within the detection region, the system will take one sampling pixel for every 3 pixels by
each row and each column (see the figure below).
Pixel Interval Illustration
·
Detection level [ 1-100] – Select a number from 1-100. The default level is 40. This sets detection
level for each sampling pixel; the smaller the value, the more sensitive it is.
· Sensitivity level [1-100] – Select a number from 1-100. The default level is 80, which means if 20%
or more sampling pixels are detected differently, the system will detect motion. The bigger the
value, the more sensitive it is. When the value is bigger, the red horizontal line in the motion
detection window will be lowered accordingly.
·
Time interval (sec) [0-7200] – Select a number from 0-7200 (seconds). The default interval is 10.
The value is the interval between each detected motion.