RV-8 70cc FLS Instructions
50
⃞
4.
Place your ignition battery inside the fuselage as shown in the above picture. Use
adhesive-backed hook and loop tape between the battery and the fuselage and secure
the battery with a hook and loop strap.
⃞
5.
Route all your wiring and make all electronic connections at this time. Secure any
permanent connections with Servo Safety Clips (FPZA1040). Be sure to secure the wiring
so that it will not bounce around in the aircraft. Also, be sure to secure the wiring in a way
the wires will not chafe over time from vibration. A typical ignition setup will be
connected as follows:
Ignition Battery
➞
Ignition Switch
➞
Ignition Regulator
➞
Ignition
➞
Engine
FUEL TANK INSTALLATION
Required for this section
Components
Tools
Adhesives/Building Materials
o
Fuselage Assembly
o
Fuel Tank
o
Fuel Line
o
Pliers
o
Hook and Loop Strap (2)
o
Adhesive-Back Hook and
Loop Tape
The Flex Innovations Lightweight 24oz Fuel Tank is included with your RV-8 70cc FLS. Before
installing the fuel tank check all fittings are properly installed and that the clunk line inside the tank is
appropriately sized.
