RV-8 70cc FLS Instructions
34
⃞
8.
Attach the linkage to the control horn. The order of hardware components, starting from
the tip of the rudder is as follows:
o
M3x15 socket head cap screw
o
M3 washer
o
Control Horn #1
o
Ball Linkage
o
Control Horn #2
o
M3 washer
o
M3 locknut
⃞
9.
With the radio powered on, make any final adjustments to the linkage length to center
the rudder accordingly.
MOUNTING THE STAB
Required for this section
Components
Tools
Adhesives/Building Materials
o
Carbon Fiber Horizontal
Stabilizer Tube
o
Left and Right Horizontal
Stabilizers
o
M3x15 Socket Head Cap
Screw (4)
o
M3 Washer (4)
o
48-inch (1220mm)
elevator extensions (2)
o
Hobby Knife with a #11
blade
o
#1 Phillips Screwdriver
o
2.5mm Hex Driver
o
Thin CA
o
Blue Thread Lock
⃞
1.
Route the (2) 48-inch (1220mm) elevator servo extensions through the holes in the
corners of the formers to keep them from bouncing around inside the fuselage. Place the
female end of the servo extension in the retention slot cutout at the exit of the fuselage.
This will prevent the extension from falling back into the fuselage.
