4-8
Section 4
Operation
Check Configuration
Settings (continued)
• The [LiSt] display for the configuration checking mode shown above
and the [LiMt] display for the maximum heating rate setting shown in
4-13 look similar but should not be confused.
(2) Press the Control Knob and check the current settings by turning
the Control Knob.
(3) After checking the settings, terminate the checking mode
[either by pressing the Control Knob]:
[or by pressing the RUN/STOP Button]:
(4) Terminate the configuration mode as described in Enter/Terminate
Configuration Mode.
Selection of Heating
Mode
You can select the heating mode (either the Temperature Priority Mode
denoted by ‘t’ or the Heating Rate Priority Mode denoted by ‘r’) as
follows:
(1) Press the CONFIG Button and select the heating mode [type]
shown below:
(2) Press the Control Knob and select either ‘r’ or ‘t’ mode by turning
the Control Knob:
