3-1
Section 3
Unpacking and Installation
Location Conditions
• Never install or use this equipment in explosive atmospheres.
• Never install or use this equipment with or near to hazardous or
flammable substances.
• Never expose this equipment to any heat sources including direct
sunlight.
• Never install this equipment closer than 20 cm (8 inches) to a wall of
combustible material.
• Never install this equipment near any device that generates high
frequency noises.
• Set up this equipment on a flat, stable, clean, non-slip, dry, and
fireproof surface inside a lab with proper safety measures.
• Observe the minimum distances (in general, 30 cm or 12 inches)
from other devices. In addition, any device which can be affected by
the motor vibrations should not be placed near this equipment.
Connecting to Power
Supply
When connecting power, use only the power cord that came with your
instrument. The power connection procedures are as follows:
(1) Before connecting the power cord, make sure that the main power
switch is turned off.
(2) Plug the power cord into the power socket at the back of your
instrument as shown in the diagram below.
(3) Plug the other end into a properly grounded and dedicated power
outlet nearby.
Figure 3-1.
Connect Power Cord
