819091D
59
12.4.21 Replacement Of Low Ambient Heater
This element is mounted in the return grill of the divider and is not replaceable. A replacement element can be
fitted onto the rear of the air duct. It is of the blanket wire type on an aluminium tape stuck to the grill itself.
1.
Disconnect the refrigerator from the power supply.
2.
Remove all the PC shelving and crisper bins.
3.
Remove the PC duct cover.
4.
Remove the PC air return grill and unplug the element from the harness.
5.
Peel the backing off the replacement element and attach the new element to the rear of the return
grill.
6.
Connect the element to the harness.
12.4.22 Replacement Of Interior Lamp
1.
Disconnect the refrigerator from the power supply.
2.
Remove the light cover. (This can be done by using a small screw driver and levering the cover
off the front clips.)
3.
The faulty light bulb is removed by pulling the bulb out of the light socket.
4.
To replace the light bulb, cut the plastic bag but do NOT touch the bulb with your fingers.
5.
Push the bulb into position
6.
Reconnect the refrigerator to the power supply.
7.
Ensure the light operates and refit the light cover.
12.4.23 Replacement of PC Door
1.
Disconnect the refrigerator from the power supply.
2.
Remove the top hinge cover to expose the wiring and water tubing.
3.
Disconnect the edge connector.
4.
Remove the left hand collet locking clip from the John Guest Fitting. (Refer Photo 0)
Collet Locking clips in position –
remove left hand clip to remove
door.
5.
Once the clip has been removed, push the collar in to remove the water tube.
6.
Remove the top hinge cover and hinge.
7.
Remove the water tube and wiring from the guide.
8. Remove
the
door.
9.
Remove the door dispensing pad, wiring and water tube from the old door and refit all
components to the new door.
10
Reassemble in reverse order.
