Fischer Panda 10000x, Manual

Page: 52 / 190

Installation Instructions
Seite/Page 52 - Kaptitel/Chapter 5: Installation Instructions 10.6.16
5.4 Air suction filter as a source of noise
The external suction filter (not included on delivery) must always be used if the generator is to be used in a dust-free
environment. This filter is connected by means of a hose with a connecting piece to the generator housing. The filter
can be the source of considerable noise. If this is the case, an air intake muffler with the appropriate nominal width
should be ordered from Fischer Panda. This is a cylinder, which takes up relatively large amount of room (Total
length approx 700mm, Diameter 100mm).
5.5 Generator Connections
The position of the connections can differ, depending on the generator type. The appropriate cables and connec-
tions are descriped at the generator.
The electrical connections MUST be carried out according to the respective valid regulations. This also con-
cernsused cable materials. The cable supplied is meant for laying „protected“ (i.e. in pipe) at a temperature
up to a max of 70 ° C (160 ° F). The on-board circuit must also be fitted with all essential fuses.
Fig. 5.5.0-1: Connection scheme
5.6 Fuel system installation
5.6.0.1 The following items need to be installed:
• Fuel supply pump (DC)
• Pre-filter with water separator (not part of the delivery)
• Fine particle fuel filter
01
02 03 04
05
07
06
01. Connection fuel IN
02. Connection fuel OUT
03. Oil drain hose
04. xControl connection panel 05. Cable for AC-Control box (not all models)
06. Load
07. Passage for starter battery cable positive (+) and
negativ (-)