Fischer Panda 10000x, Manual

Page: 151 / 190

Safety Instructions Panda xControl
10.6.16 Kapitel/Chapter 10: Safety Instructions Panda xControl - Seite/Page 151
10. Safety Instructions Panda xControl
10.1 Personal requirements
The settings described here can by performed by the operator, unless otherwise indicated.
The installation should be carried out by specially trained personnel or by authorized repair shops (Fischer Panda
service points).
10.2 Safety instructions
Note! Follow the general safety instruction at the front of this
manual.
If these not exist, they can be requested at Fischer Panda
GmbH, 33104 Paderborn.
Warning! Automatic start Danger for life! - The generator can be equipped with a
automatic start device. This means expected starting of
the generator, the starter battery must the generator can
be started by an external signal. To avoid an unexpected
starting of the generator, the starter battery must be
disconnected before start working at the generator.
Warning! The generator must not be put into operation with cover
removed.
If the generator is mounted without sound cover, the rotating
parts (pulley, belt, etc.) must be covered and protected so
that an injury is excluded.
All service, maintenance or repair work on the unit may be
made only while the motor is off.
Warning! Danger of Life - High voltage Danger for Life. Improper handling, operation,
installation and maintenance can result in severe
personal injury and/or material damage.
Electrical voltages above 60 volts DC and 25V AC are always
dangerous to life). The rules of the respective regional
authority must be adhered to. Only an electrician may carry
out installation of the electrical connections for safety
reasons.
Attention! Disconnect the battery when working on the generator.
The battery must always be disconnected (first negative then
positive pole), when work on the generator or the electrical
system of the generator are made, so that the generator can
not be started accidentally.
This is especially true for systems with an automatic start
function. The automatic start function is to be deactivated
before the work.
Sea valve must be closed. (only PMS version)