9
MicroM Hookup
It is assumed the MicroM is mounted in a burner cabinet remote from the inTouch device.
•
In accordance with local wiring codes, connect the twisted shielded pair (Belden P/N 8945) to
the appropriate terminals located on the MicroM daughter board.
FIGURE 4.
MICROM DAUGHTER BOARD
•
Run the cable to either the next device to be multi-dropped or to the inTouch device.
•
Feed the cable into one of the knockout locations under the protective cover.
•
Splice the twisted shielded cable onto a telephone style connector using the black (A) and yel-
low (B) wires. Plug the RJ11 type connector in either communication port of the inTouch
device.
•
Replace the protective plastic cover.
•
Configure the unit address of the MicroM.
•
Set dipswitch 2 on inTouch to 4800 baud.
•
Verify communcations.
BurnerLogix Hookup
•
It is assumed the BurnerLogix is mounted in a burner cabinet remote from the inTouch device.
Refer to Figure 6 on page 10 for an illustration overview.
•
Plug the ED512 cable into either of the telephone style jacks located in the underside of the
YB110 or ZB110 module. Refer to Figure 5 on page 10
•
Connect the other end of the ED512 into the mating connector located on the ED610.
•
In accordance with local wiring codes, connect the twisted shielded pair (Belden P/N 8761) to
terminals 9 and 10 of the ED610 adapter and run the cable to either the next device to be multi-
dropped or to the inTouch device. Refer to Figure 6 on page 10 for suggested wiring diagram.
•
Feed the cable into one of the knockout locations under the protective cover.
•
Splice the twisted shielded cable onto a telephone style connector using the black (A) and yel-
low (B) wires. Plug the RJ11 type connector in either communication port of the inTouch
device.
•
Replace the protective plastic cover.
•
Set baud rate on inTouch dipswitch 2 to match the baud rate of BurnerLogix controls. (Note: All
devices must be the same baud rate).
•
Configure the unit address of the BurnerLogix.
•
Verify communications.
SERIAL COMMUNICATIONS
A
B
REMOTE DISPLAY
RJ45 JACK
REMOTE RESET
(RS485)
(+)
(-)
