7
Record Equipment Information
•
Either fill in the enclosed MONITORED EQUIPMENT I.D. CARD with the fields described
below or call your home office with all the following information:
•
The
Location Name
for the piece of equipment being monitored.
•
The exact
Street Address,
and the
City, State,
and
Zip code
where the transmitter is located.
•
The
Local Contact Phone
and
Name
should be the phone number and name of the person(s)
who would need to be contacted to gain access to this transmitter.
•
The
Device ID
number located on the black protective cover inside the transmitter. This is also
preprinted on the INSTALLATION card.
•
The
Equipment Name
for the piece of equipment being monitored. Try to be as specific as possi-
ble, especially if there are multiple pieces of equipment which will have transmitters installed at
a single site. Possible examples are North Roof Top AC, Boiler-5, Store A Refrigeration 3, etc.
•
The
Equipment Manufacturer, Model,
and
Serial Number
. This information should be sufficient
to identify repair or replacement parts before a service person is dispatched to the site.
IMPORTANT: If this transmitter has not been configured previously, DO NOT leave the site
without recording the Device ID number. Without this number, the device cannot be config-
ured at the web site.
Testing
•
To complete the test, the transmitter must be configured at the Fireye web site (see Configuring
the Device Messaging section). Note that while the following test is recommended, the transmit-
ter will send out a Heartbeat message every night. Therefore, it is possible to wait until the next
morning to determine if the transmitter sent out a message.
•
The yellow status light should be flashing once per second (see Figure 2 on page 7). This indi-
cates the transmitter registers service, is available and is ready to send. The green status light
should not be on.
•
Press the Service Button and then release it.
•
The yellow light should now come on. The green light will flash several times. When the green
light flashes quickly for approximately 2 seconds, the message has been sent.
•
After the message has been successfully sent, the green light will once again be off, and the yel-
low light should flash every second showing the transmitter is ready to send another message.
•
Check the Fireye website to be sure the message was received.
FIGURE 2.
STATUS LIGHTS
No Service Available
Service Available, Ready to Transmit
Transmitting Message
Successful Transmission
YELLOW
YELLOW
YELLOW
YELLOW
GREEN
GREEN
GREEN
GREEN
OFF
OFF
FLASHING
OFF
ON
FLASHES
ON
FLASHES
Once/Second
Once or Twice
2 Second Rapidly
