14
Input the Device ID number
•
Before you can enter setup a new transmitter, you must know its ID number.
•
The ID number for the transmitter is on a label on the radio and should be printed on the Moni-
tored Equipment card which was provided with the unit.
•
Enter the ID number and click the
Submit
button.
FIGURE 10.
INSTALL NEW DEVICE
New Equipment Location
•
The
New Equipment Location
form (see Fig. 9) refers to the equipment this transmitter is moni-
toring. If there are multiple pieces of equipment with transmitters in a single location, the infor-
mation supplied should be sufficient to identify this particular piece of equipment from any
others.
•
All the information should be recorded on the MONITORED EQUIPMENT I.D. CARD pro-
vided.
•
All the fields marked with check boxes are required.
•
Do not use abbreviations such as
St
for Street or
Rd
for Road if you plan to use the voice mes-
sage delivery.
•
Do not use uppercase letters for words if you plan to use for voice message delivery (example -
use “flow” not “FLOW”) as the synthesized voice will annunciate the individual letters not the
word.
•
The address fields should have the address where the transmitter is installed.
•
The contact information should contain the name and phone number of the individual(s) who
can provide access to the particular piece of equipment.
•
The bottom four fields identify the equipment. It is important to get as much information about
the equipment being monitored as possible. The information should be sufficient so a service
person can get any appropriate parts for maintenance or repair before going to the equipment
site.
•
A sample e-mail message containing all the equipment information is shown on later in this sec-
tion.
THE DEVICE ID IS MARKED
ON THE RADIO IN THE INTOUCH
UNIT AND ON THE
INSTALLATION CARD PROVIDED
CLICK HERE AFTER ENTERING
DEVICE ID NUMBER
