37
THE PASSWORD MENU
Password
A four-digit Password is required to enter the CONFIG menus. If a Password is not entered, pressing
the SELECT key will advance directly to the “Flame Quality” display.
To enter the CONFIG menus, you must enter the four-digit Password.
The following example is for
the factory installed password of 0205:
1.
With “SELECT to Enter Configure Menu” displayed, depress the SELECT key. “
0
xxx” will be
displayed, the first digit (“0”) is adjustable. (If the factory password was changed, use the UP/
DOWN keys to select the appropriate first digit).
2.
With the first digit selected (e.g. “0xxx”) depress the PROGRAM key. “00xx” will be displayed,
the second digit (“0”) is adjustable. Depress the UP key twice to display “2”. (If the factory
password was changed, use the UP/DOWN keys to select the appropriate second digit).
3.
With the second digit selected (e.g. “02xx”) depress the PROGRAM key. “02
0
x” will be dis-
played, the third digit (“0”) is adjustable. (If the factory password was changed, use the UP/
DOWN keys to select the appropriate third digit).
4.
With the third digit selected (e.g. “020x”) depress the PROGRAM key. “020
0
” will be dis-
played, the fourth digit (“0”) is adjustable. Depress the UP key five times to display “5”. (If the
factory password was changed, use the UP/DOWN keys to select the appropriate fourth digit).
5.
With all four digits selected (e.g. “0205”) depress the PROGRAM key.
If the Password was not entered correctly, the display will return to “ENTER PW DIGIT 1”. Use the
UP/DOWN keys to select the appropriate first digit.
If the Password was entered correctly, the display will read “PASSWORD ENTERED. To change
the password, Press DOWN key once to PASSWORD. If you wish to change the password at this
time, Press the SELECT key see the “Change Password” section below. Otherwise, depress the
DOWN key to advance to the CONFIG menus.
Entering the correct Password allows the user 20 minute access to the CONFIG menus. Saving any
parameter will re-start this 20 minute time-out period. When the user returns to the MAIN STATUS
menu, the password will immediately expire. The password must be re-entered if it is necessary to
return to the CONFIG menu.
Change Password
The user may change the password
(the factory set password is “0205”)
to any four-digit code
desired. To change the password, you first enter the current password as described above.
Scroll until the display reads “PASSWORD”. Press SELECT and “CHNGE PW DIGIT 1 0xxx” is
displayed. The first digit “0” is adjustable. For example, to enter a NEW password of “1357”, use the
UP/DOWN key and the PROGRAM key as described in the above section. When complete, the dis-
play will briefly read “PASSWORD CHANGED 1357”.
Removing Password Protection
The user may choose to disable / remove password protection for an extended period of time during
commissioning, and then restore password protection at a later time when commissioning is com-
plete.
To remove password protection, first enter the current password, and then change it to "0000" fol-
lowing the steps described in the Change Password section above. When the password has been
changed to "0000", the user will no longer be prompted to enter a password to gain access to the
CONFIG menus.
To restore password protection, enter the CONFIG menu and depress the DOWN key until "PASS-
WORD 0000" is displayed. Press the SELECT key and follow the steps described in the Change
Password section above to change from "0000" to either the as-shipped password of "0205", or to
any other four-digit code desired.