Firex PM.IV Series, Instruction Manual For Installation, Maintenance And Use

Page: 30 / 123

Instruction manual for installation, maintenance and use
Steam heated kettles PM.IV...
- GB -
Page
6 di 25
1.3. CONSTRUCTION
−
Main structure in steel with 4 adjustable height feet.
−
Panels in stainless steel AISI 304, thickness 10-12/10.
−
Cooking vat in stainless steel AISI 316, thickness 20/10.
−
Stainless steel jacketed lid with hinge and spring balancing in all open positions.
−
Jacket and lining in stainless steel AISI 304, thickness 15-20/10.
- Jacket pressure is controlled by a safety valve set at 0.5 bar; the appliance is equipped with an analogue
pressure gauge.
−
Chrome-plated brass drainage tap.
−
Max. steam operating pressure: 0,45 bar.
−
Steam inlet adjustment valve.
1.4. DETAILS ONLY FOR PRESSURE KETTLES
−
Stainless steel lid with heat-resistant silicone gasket.
−
Hermetic closing of lid ensured by 4 screw clamps.
−
The relief valve for the pressure that develops inside the cooking vat is set at 0,05 bar.
−
On request, the appliance can be equipped with a pressure gauge indicating the pressure inside the
cooking vat.
1.4.1. LAWS, TECHNICAL PRESCRIPTIONS AND DIRECTIVES
When installing the appliance it is necessary to follow and comply with the following regulations:
−
current regulations on the matter;
−
any hygienic-sanitary regulations concerning cooking environments;
−
municipal and/or territorial building regulations and fire prevention prescriptions;
−
current safety standards;
−
regulations and prescriptions regarding steam output;
−
any other local prescriptions.
2.1. INSTALLATION
Warning! : Only qualified technicians must perform the installation, maintenance and test of the
appliance.
−
The appliance must be installed in a well-aired room, possibly under an exhaust hood.
−
Remove all the packaging and check that the appliance is in perfect conditions. In case of visible
damage, do not connect the appliance and notify the sales point immediately.
−
Remove the PVC protection from the panels.
−
Dispose of packaging according to regulations. Generally material is divided according to composition
and should be delivered to the waste disposal service.