CAUTION
: Children and adults should be alerted to the hazards on high surface temperatures and should stay away to
avoid burns or clothing ignition. Young children should be carefully supervised when they are in the area of the appliance.
WARNING:
Do not use this appliance if any part has been under water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of control system and any gas control, which has been under water.
OPERATION
SAFETY WARNINGS
1. Never leave the fireplace unattended during operation.
2. Clothing or other flammable materials should not be placed on or near the appliance.
3. Any guard or other protective device removed for servicing the appliance must be replaced prior to operating the
appliance.
4. Installation and repair should be done by a qualified service person. The appliance should be inspected before
use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It
is imperative the control compartment, burners and circulating air passageways of the appliance be kept clean.
5. Inspect the fuel supply connection before each use of the appliance.
6. Temporary storage of this appliance indoors is permissible only if it has been disconnected from its fuel supply
(Natural or L.P. gas line).
WARNING
1. This appliance is hot when operated and can cause severe burns if contacted.
2. Do not burn any solid fuels in this appliance.
LIGHTING INSTRUCTIONS
NOTE
: It may take several cycles of ON/OFF to purge the airflow from the gas lines. The pilot ignition will turn OFF after
20 seconds if the burner does not light after which you will need to press transmitter OFF button then back ON to initiate
ignition again.
Flame height can be adjusted HI and LO. After the fireplace is operating press the handheld transmitter HI or LO.
The fireplace defaults to the HI setting when initially lighting the fireplace each time or if attempting to re-light but will
remember the last setting used and change back to that last setting in approximately 5 seconds after lighting.
READ ALL WARNING AND SAFETY INFORMATION ABOVE BEFORE ATTEMPTING TO LIGHT FIREPLACE
LOW
HI
OFF
ON
TURNING OFF THE FIREPLACE
1. To turn OFF the fireplace press the OFF button on the transmitter. Fireplace will turn OFF.
2. After fireplace has completely cooled off install cover.
Fig. 31
Transmitter
TURNING ON THE FIREPLACE
1. Ensure you have leak tested the fireplace before operating. Turn main gas supply ON.
2. Ensure batteries are installed in battery pack and switch is on Latching Solenoid.
3. Press the ON button on the transmitter. You will hear the ignitor probe will begin sparking
for up to 20 seconds and the fireplace will turn ON.
4. If the fireplace does not light the module will “beep” one time every second indicating an
ignition error. This is a hard lockout. If this occurs press the
OFF
button on the remote
control and repeat step 1-3.
5. If fireplace does not light after second try turn main gas OFF, wait 5 minutes and repeat
steps 1-3.
REV. 1-5-17 Page 22
Kalea Bay Outdoor Fireplace
Summary of Contents for OFP-L36TFS-N
Page 32: ...NOTES ...
