REV. 1-5-17 Page 12
Kalea Bay Outdoor Fireplace
SEE-THROUGH FIREPLACE INSTALLATION ONLY
If you have determine to install the fireplace as a see-through model then you will need to remove the rear back panel to
convert it. Before removing the back panel be sure to remove the contents out of the firebox area.
Use the following steps:
Step 1:
Look at the back side of the fireplace. Around the outer perimeter area of the frame or back wall are several
screws to remove (See the shaded area in Fig. 10).
CAUTION:
Watch for sharp edges.
Note:
The numbers of screws
to remove will vary with each fireplace model.
Step 2:
The back panel will not be used again in the see-through application. Discard back panel and screws.
BACK VIEW REAR PANEL INSTALLED
BACK VIEW REAR PANEL REMOVED
Bottom Finish Fin
Hood
Fig. 10
Removing back wall to convert to see-through model.
NOTE:
When converting to the see-through fireplace the windsheid clips will need to be installed. See figures 25 and 26
on pages 18 & 19. Two windshield clips are already be installed for a single-sided fireplace, the other two clips will need
to be installed for a see-through model. The clips will be packaged with the glass windshields. The retaining screws for
the clips are already installed in the fireplace. Simply remove the screws and reattach with the windshield clips in place
as shown in Fig 26. The see-through fireplace does require both windshields to be installed for proper operation.
The bottom support fin (Fig. 10) has pre-punched holes on inside edge to secure fin into place before attaching
cement board and the additional hood will need to be installed.
Summary of Contents for OFP-L36TFS-N
Page 32: ...NOTES ...
