REV. 1-5-17 Page 19
Kalea Bay Outdoor Fireplace
FINAL PREPARATION
WINDSHIELD INSTALLATION
The glass windshield(s) slide into the two clips on each end
of the fireplace and rest in position if installing for a
single-sided fireplace (See Fig. 25) for the location. If
you are installing a see-through fireplace, you will need to
install two additional glass clips (provided) into the opposite
side of the fireplace in the same location as the existing
clips. Use the two screws installed in the fireplace side wall
to secure the clips (glass holders). There are two glass
windshields provided to install on each side of the fireplace.
The glass will rest on the bottom tab of each windshield
clip.
CAUTION:
THIS IS TEMPERED GLASS. DO NOT CHIP
GLASS. CHIPPED TEMPERED GLASS CAN BREAK
WITHOUT WARNING.
NOTE:
If you are not using the extra windshield provided it
can be used as a replacement part.
INSTALLING WINDSHIELD INTO CLIPS
1. Carefully unpackage the windshield(s).
2. Using gloves carefully lift the windshield into the top
opening (above the clips) of the fireplace, supporting
the glass at the top and bottom as you handle it.
3. Carefully bring the bottom edge of the glass into the
top area of the windshield clip (See Fig. 26).
4. As the glass enters the clip the bottom edge of the
glass will rest in place on the bottom of the clip.
5. Center glass between clips after installation.
1
2
GLASS
WINDSHIELD
GLASS WINDSHIELD
Side View
Installing Glass
Side View of
Installed Glass
Fig. 26
Installing windshield into clips (glass holders).
BURNER P
AN ASSEMBL
Y
Pilot
(Hidden Underneath)
Burner
Tube
Ignition
Hole
PILOT OPERATION
The pilot assembly is located at the end of the burner hidden
underneath a pilot cover. Ensure the pilot flame is passing
through the ignition hole in the burner pan for proper ignition.
Use the Fig. 27 as a guide.
CAUTION:
Ensure there is no media in the ignition hole area.
The burner tube gas ignites in this area to light the fireplace.
Media in this area could cause delayed ignition.
Fig. 27
Proper pilot flame through ignition
hole.
Summary of Contents for OFP-L36TFS-N
Page 32: ...NOTES ...
