I
NSTALLATION OF BATTERY PACK
1. The battery pack should be installed into the either end
of the fireplace no higher than 11 ½” from the bottom.
A plastic junction box is provided for the installation of
the battery pack (See Figs. 16-18). We recommend a
weather resistance cover to protect battery pack.
2. The wiring extending from the valve box is a 12-foot
special 4-pin connector that connects to the battery
pack and (2) two additional wires with ¼” female
connectors. A complete wiring diagram (Fig. 32) is
located on page 28.
3. Feed all wires into the plastic junction box and
connect special 4-pin plug into back of the battery
pack. Connect ¼” female spade connectors to
solenoid wires matching color, red-to-red and black-to-
black.
4. Install the (4) AA batteries in to the battery
compartment shown in Fig 17. Double check to ensure
the slide switch is in the Latching Solenoid position on
the battery pack. Then snap cover plate in place as
shown in Fig.18.
Requires 4-AA 1.5V
alkaline batteries
Batt
ery c
over
slid
es o
n/off
La
tc
hin
g S
ole
no
id
D
C
M
oto
r D
riv
e
Slide Switch
to Latching
Solenoid
Fig. 17
Slide switch on latching solenoid
5. Reinstall the battery pack into the plastic junction box, line up the two holes in the cover and install white screws
provided. Batteries can be changed or installed by removing the two screws that hold the cover plate battery pack
in place. Remove assembly, slide cover away from the cover plate and install the (4) four AA batteries.
6. Be sure the batteries are installed positive-to-positive and negative-to-negative. If one battery is installed wrong
the system will not operate.
7. Once the fireplace is installed into the enclosure, the burner and control system should be tested before the
media (rocks/glass) are installed.
INSTALLATION OF BATTERY INTO TRANSMITTER
You have one handheld transmitter and you will need to install the included (12-volt
battery) into the transmitter. On the backside of the transmitter, push the cover away from
the case. Place the battery into the compartment matching positive-to-positive and
negative-to-negative. To ensure the battery is properly installed push any button on the
transmitter and you will see a red LED light at the top of the transmitter glow. The red LED
light above the ON button will only be lit when button is pushed.
See Fig. 19.
CAUTION:
Handheld transmitter should not be left outside exposed to the elements when
fireplace is not in use.
Fig. 18
Cover plate installation
Battery Pack
Cover Plate
(Rear View)
12
V
12
V Ba
tter
y
Fig. 19
Battery installation into remote control.
Kalea Bay Outdoor Fireplace
REV. 1-5-17 Page 15
Battery Pack
11½”
Battery
Pack
Vent
Fig.16
Battery pack location in end of fireplace.
FINAL PREPARATION
Summary of Contents for OFP-L36TFS-N
Page 32: ...NOTES ...
